u-boot.git/test, branch v2015.07-rc2

dm: pci: Allow PCI bus numbering aliases

2015-06-04T09:34:47+00:00

Commit 9cc36a2 'dm: core: Add a flag to control sequence numbering' changed
the default uclass behaviour to not support bus numbering. This is incorrect
for PCI and that commit should have enabled the flag for PCI.

Enable it so that PCI buses can be found and the 'pci' command works again.
Also add a test for this.

Signed-off-by: Simon Glass

add test for two 'loadables'

2015-05-28T12:18:21+00:00

Nothing too fancy.  A simple test that attmpts to load two loadables and
verify that they are properly unpacked in the u-boot sandbox.
Signed-off-by: Karl Apsite 
Reviewed-by: Simon Glass

test: env: Add a test of the new regex behavior for attrs

2015-05-21T13:16:18+00:00

The behavior of the env attrs depends on CONFIG_REGEX. Add an additional
test if that variable is set.

Signed-off-by: Joe Hershberger 
Reviewed-by: Simon Glass

test: env: Add test for verifying env attrs

2015-05-21T13:16:18+00:00

Add a test of the env_attr_lookup() function.

Signed-off-by: Joe Hershberger 
Reviewed-by: Simon Glass

test: env: Add test framework for env

2015-05-21T13:16:18+00:00

Add a new "env" subcommand to the ut command.

This will run unit tests on the env code. This should be targetable to
any device that supports the env features needed for the tests.

Signed-off-by: Joe Hershberger 
Reviewed-by: Simon Glass

test: dm: Recover the driver model tree after tests

2015-05-21T13:16:18+00:00

Put the driver model for the system back into a good state after
completing the DM testing.

Signed-off-by: Joe Hershberger 
Acked-by: Simon Glass

test: dm: eth: Handle failed test env cleanup

2015-05-21T13:16:17+00:00

Make sure that the env gets cleaned up after a test fails so that other
tests aren't affected.

Signed-off-by: Joe Hershberger

test: dm: Don't bail on all tests if one test fails

2015-05-21T13:16:17+00:00

There's not much point in having a failure count if we always give up on
the first failure. Also stop clearing the entire state between tests.

Make sure that any failures are still passed out to the command line.

Signed-off-by: Joe Hershberger 
Reviewed-by: Simon Glass

test: Move the unit tests to their own menu

2015-05-21T13:16:17+00:00

Make all unit tests selectable as a menu of test suites instead of just
sitting in the top-level menu individually.

Signed-off-by: Joe Hershberger 
Acked-by: Simon Glass

test: dm: Move the time test over to the ut command

2015-05-21T13:16:17+00:00

Unify the command for running unit tests further by moving the "ut_time"
command over to "ut time".

Signed-off-by: Joe Hershberger