Compiling with CONFIG_UNIT_TEST=y leads to:

aarch64-linux-gnu-ld.bfd:
test/lib/sscanf.c:50: undefined reference to `sscanf'

Add missing build dependency.

Fixes:e87dfb0526be ("lib: sscanf: add sscanf implementation")
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>

- Add basic Marvell/Cavium OcteonTX/TX2 support (Suneel)
- Infrastructure changes to PCI uclass to support these SoC's (Suneel)
- Add PCI, MMC & watchdog driver drivers for OcteonTX/TX2 (Suneel)
- Increase CONFIG_SYS_MALLOC_F_LEN for qemu-x86 (Stefan)

- Squashfs compression support
- Coverity fixes
- XEN guest updates
- Finish previous MediaTek updates
- Arm Total Compute platform support

Enable PCI memory regions in ranges property to be of multiple entry.
This helps to add support for SoC's like OcteonTX/TX2 where every
peripheral is on PCI bus.

Signed-off-by: Suneel Garapati <sgarapati@marvell.com>
Cc: Simon Glass <sjg@chromium.org>
Cc: Bin Meng <bmeng.cn@gmail.com>

Pull request for UEFI sub-system for efi-2020-10-rc3 (3)

The following bug fixes are contained in this pull-request:

* ResetSystem() should no hang if not implemented.
* Device paths in Bootxxxx variables should be verified.
* Use ':' as separator for command setenv -e -i instead of ','.
* Correct comments for functions.
* Update UEFI documentation.

Improve SquashFS tests architecture. Add 'Compression' class. LZO
algorithm may crash if the file is fragmented, so the fragments are
disabled when testing LZO.

Signed-off-by: Joao Marcos Costa <joaomarcos.costa@bootlin.com>

setenv -e -i <address>,<filesize> can be used to set a UEFI variable
from memory.

For separating an address and a size we use ':' in most commands.
Let's do the same for setenv -e -i.

Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>

Provide a unit test for function efi_dp_check_length().

Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>

- Add CCF clocks definitions for iMX6Q enet (ETH)
- Several fixes for CCF framework - the most notable is the one, which
  adds get_rate helper to clk-mux.c
- Improvements for clk command - better visibility and alignment.

The previous version of the get_rate helper does not work if the mux
clock parent is changed after the probe. This error has not been
detected because this condition has not been tested. The error occurs
because the set_parent helper does not change the parent of the clock
device but only the clock selection register. Since changing the parent
of a probed device can be tricky, the new version of the get_rate helper
provides the rate of the selected clock and not that of the parent.

Signed-off-by: Dario Binacchi <dariobin@libero.it>