Dynamically going through the subnode array and deleting leads to
templates being skipped from deletion when templates are consecutive in
the subnode list. Prevent this from happening by first parsing the DT
and then deleting the nodes. Add a testcase as well for this cornercase.

Signed-off-by: Neha Malcom Francis <n-francis@ti.com>

Input directories can be passed to binman using the '-I' option and those
input directories are now also passed to 'dtc' when run by binman.

Signed-off-by: Paul HENRYS <paul.henrys_ext@softathome.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

FIT provides a way to select between different devicetree blobs
depending on the model. This works fine for U-Boot proper and allows SPL
to select the correct blob for the current board at runtime. The boot
sequence (SPL->U-Boot proper) is therefore covered by the existing
feature set.

The first boot phase (typically TPL) cannot use FIT since SoC boot ROMs
don't currently support it. Therefore the TPL image must be specific to
each model it boots on.

To support booting on mulitple models, binman must therefore produce a
separate TPL image for each model, even if the images for the rest of
the phases are identical.

TPL needs to be packaged as an executable binary along with a reduced
devicetree. When multiple models are supported, a reduced devicetree
must be provided for each model.

U-Boot's build system is designed to build a single devicetree for SPL
builds, so does not support this requirement.

Add a new 'alternatives' feature to Binman, allowing it to automatically
subset a devicetree to produce the reduced devicetree for a particular
phase for each supported model. With this it is possible to produce a
separate TPL image for each of the models. The correct one can then be
loaded onto a board, along with the common FIT image(s).

Signed-off-by: Simon Glass <sjg@chromium.org>

This has become quite long, so move it into a separate function.

Signed-off-by: Simon Glass <sjg@chromium.org>

For tests which fake bintools being missing, we need to reset the list
afterwards, to ensure that future tests do not also see the bintools as
missing.

Reset the list when processing is complete.

Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Neha Malcom Francis <n-francis@ti.com>

The affected boards have been fixed, so drop this hack.

This reverts commit 288ae53cb73605500b7fc01e5919753c878466be.

Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Tim Harvey <tharvey@gateworks.com>

Three boards use a phandle in a FIT generator and the maintainer is
away. For now, add a hack to allow this.

Signed-off-by: Simon Glass <sjg@chromium.org>

This provides support for phandles to be copied over from templates. This
is not quite safe, since if the template is instantiated twice (i.e. in
two different nodes), then duplicate phandles will be found. This will
result in an error.

Signed-off-by: Simon Glass <sjg@chromium.org>

It is not necessary to keep templates around after they have been
processed. They can cause confusion and potentially duplicate phandles.

Remove them.

Use the same means of detecting a template node in _ReadImageDesc so that
the two places are consistent.

Signed-off-by: Simon Glass <sjg@chromium.org>

This file aids debugging when binman fails to get far enough to write out
the final devicetree file. Write it immediate after template processing.

Signed-off-by: Simon Glass <sjg@chromium.org>