u-boot.git/tools/env/fw_env.c, branch origin

* Code cleanup, mostly for GCC-3.3.x

2004-12-31T09:32:47+00:00

* Cleanup confusing use of CONFIG_ETH*ADDR - ust his only to
  pre-define a MAC address; use CONFIG_HAS_ETH* to enable support for
  additional ethernet addresses.

* Cleanup drivers/i82365.c - avoid duplication of code

* Fix bogus "cannot span across banks" flash error message

* Add support for CompactFlash for the CPC45 Board.

Patch by Murray Jensen, 20 Jun 2003:

2003-06-21T00:17:24+00:00

- hymod update
- cleanup (especially for gcc-3.x compilers)

* Patch by Lutz Dennig, 10 Apr 2003:

2003-04-12T23:38:12+00:00

  Update for R360MPI board

* Add new meaning to "autostart" environment variable:
  If set to "no", a standalone image passed to the
  "bootm" command will be copied to the load address
  (and eventually uncompressed), but NOT be started.
  This can be used to load and uncompress arbitrary
  data.

* Set max brightness for MN11236 displays on TRAB board

* Add support for 16 MB flash configuration of TRAB board

2003-02-28T00:49:47+00:00

* Patch by Erwin Rol, 27 Feb 2003:
  Add support for RTEMS

* Add image information to README

* Fix dual PCMCIA slot support (when running with just one
  slot populated)

* Add VFD type detection to trab board

* extend drivers/cs8900.c driver to synchronize  ethaddr  environment
  variable with value in the EEPROM

* Start adding MIPS support files

Add "pcidelay" environment variable (in ms, enabled via CONFIG_PCI_BOOTDELAY).

2003-02-14T11:21:23+00:00

* Restrict baudrate settings on LWMON to higher speeds

2003-01-11T09:48:40+00:00

  when watchdog is on

* Update baudrate in bd_info when it gets changed

* Add watchdog trigger points while waiting for serial port
  (so far only 8xx -- needed on LWMON with 100ms watchdog)

* Improve command line tool to access the U-Boot's environment
  (figuration of the utility, using a config file)

* Use 1-byte-read instead of -write for iprobe() function

2002-12-17T01:51:00+00:00

  Add i2c commands to PM826 config

* extend I2C POST code: check for list on known addresses