| Age | Commit message (Collapse) | Author |
|---|
|
This IP is also used on some arm SoC, so we allow to
use it on arm bcm68360 too.
Signed-off-by: Philippe Reynes <[email protected]>
|
|
Allow the led bcm6858 driver to be used on bcm63158.
They have the same led controller.
Signed-off-by: Philippe Reynes <[email protected]>
|
|
The driver add the support of the led IP on bcm6858.
This led IP can drive up to 32 leds, and can handle
blinking.
Signed-off-by: Philippe Reynes <[email protected]>
Reviewed-by: Daniel Schwierzeck <[email protected]>
|
|
This driver is a simplified version of linux/drivers/leds/leds-bcm6358.c
Signed-off-by: Álvaro Fernández Rojas <[email protected]>
Reviewed-by: Simon Glass <[email protected]>
|
|
This driver is a simplified version of linux/drivers/leds/leds-bcm6328.c,
simplified to remove HW leds and blink fallbacks.
Signed-off-by: Álvaro Fernández Rojas <[email protected]>
Reviewed-by: Simon Glass <[email protected]>
|
|
Allow LEDs to be blinked if the driver supports it. Enable this for
sandbox so that the tests run.
Signed-off-by: Simon Glass <[email protected]>
Reviewed-by: Ziping Chen <[email protected]>
|
|
There should be a blank line between each option. Add one before LED_GPIO.
Signed-off-by: Simon Glass <[email protected]>
Reviewed-by: Ziping Chen <[email protected]>
|
|
Move all of the status LED feature to drivers/led/Kconfig.
doc/README.LED updated to reflect the Kconfig implementation.
Tested boards: CL-SOM-AM57x, CM-T335
Signed-off-by: Uri Mashiach <[email protected]>
|
|
At present SPL does not have its own option. But these features can
increase SPL code size. Adjust the Kconfig and Makefile so that
separate a SPL option can be selected.
Signed-off-by: Simon Glass <[email protected]>
|
|
Signed-off-by: Masahiro Yamada <[email protected]>
Reviewed-by: Tom Rini <[email protected]>
Reviewed-by: Simon Glass <[email protected]>
|
|
The menuconfig for drivers are getting more and more cluttered
and unreadable because too many entries are displayed in a single
flat menu. Use hierarchic menu for each category.
Signed-off-by: Masahiro Yamada <[email protected]>
Reviewed-by: Simon Glass <[email protected]>
[trini: Update to apply again in a few places, drop USB hunk]
Signed-off-by: Tom Rini <[email protected]>
|
|
Add a simple driver which allows use of LEDs attached to GPIOs. The linux
device tree binding is used.
Signed-off-by: Simon Glass <[email protected]>
|
|
Add a simple uclass for LEDs, so that these can be controlled by the device
tree and activated when needed. LEDs are referred to by their label.
This implementation requires a driver for each type of LED (e.g GPIO, I2C).
Signed-off-by: Simon Glass <[email protected]>
|
