From 81e33f4b65171a7dcb99a3efd9b3a45da129a21a Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Mon, 21 Dec 2015 13:56:33 +0100 Subject: arm: mvebu: Move SoC selection (A38X vs AXP) into Kconfig Until now, the SoC selection for the ARCH_MVEBU platforms has been done in the config header. Using CONFIG_ARMADA_XP in a non-clear way. As it needed to get selected for AXP and A38x based boards. This patch now changes this to move the SoC selection to Kconfig. And also uses CONFIG_ARCH_MVEBU as a common define for both AXP and A38x. This makes things a bit clearer - especially for new board additions. Additionally the defines CONFIG_SYS_MVEBU_DDR_AXP and CONFIG_SYS_MVEBU_DDR_A38X are replaced with the already available CONFIG_ARMADA_38X and CONFIG_ARMADA_XP. And CONFIG_DDR3 is removed, as its not referenced anywhere. Signed-off-by: Stefan Roese Cc: Luka Perkov --- drivers/Makefile | 4 ++-- drivers/block/mvsata_ide.c | 6 +++--- drivers/i2c/mvtwsi.c | 2 +- 3 files changed, 6 insertions(+), 6 deletions(-) (limited to 'drivers') diff --git a/drivers/Makefile b/drivers/Makefile index c9031f2ce87..00da40b704a 100644 --- a/drivers/Makefile +++ b/drivers/Makefile @@ -14,8 +14,8 @@ obj-$(CONFIG_SPL_I2C_SUPPORT) += i2c/ obj-$(CONFIG_SPL_GPIO_SUPPORT) += gpio/ obj-$(CONFIG_SPL_MMC_SUPPORT) += mmc/ obj-$(CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT) += ddr/fsl/ -obj-$(CONFIG_SYS_MVEBU_DDR_A38X) += ddr/marvell/a38x/ -obj-$(CONFIG_SYS_MVEBU_DDR_AXP) += ddr/marvell/axp/ +obj-$(CONFIG_ARMADA_38X) += ddr/marvell/a38x/ +obj-$(CONFIG_ARMADA_XP) += ddr/marvell/axp/ obj-$(CONFIG_ALTERA_SDRAM) += ddr/altera/ obj-$(CONFIG_SPL_SERIAL_SUPPORT) += serial/ obj-$(CONFIG_SPL_SPI_FLASH_SUPPORT) += mtd/spi/ diff --git a/drivers/block/mvsata_ide.c b/drivers/block/mvsata_ide.c index 52c16025f89..2c6d42410cb 100644 --- a/drivers/block/mvsata_ide.c +++ b/drivers/block/mvsata_ide.c @@ -13,7 +13,7 @@ #include #elif defined(CONFIG_KIRKWOOD) #include -#elif defined(CONFIG_ARMADA_XP) +#elif defined(CONFIG_ARCH_MVEBU) #include #endif @@ -102,7 +102,7 @@ struct mvsata_port_registers { * Initialize SATA memory windows for Armada XP */ -#ifdef CONFIG_ARMADA_XP +#ifdef CONFIG_ARCH_MVEBU static void mvsata_ide_conf_mbus_windows(void) { const struct mbus_dram_target_info *dram; @@ -174,7 +174,7 @@ int ide_preinit(void) int ret = MVSATA_STATUS_TIMEOUT; int status; -#ifdef CONFIG_ARMADA_XP +#ifdef CONFIG_ARCH_MVEBU mvsata_ide_conf_mbus_windows(); #endif diff --git a/drivers/i2c/mvtwsi.c b/drivers/i2c/mvtwsi.c index f20d1b22915..5dc4fbba1fe 100644 --- a/drivers/i2c/mvtwsi.c +++ b/drivers/i2c/mvtwsi.c @@ -20,7 +20,7 @@ #if defined(CONFIG_ORION5X) #include -#elif (defined(CONFIG_KIRKWOOD) || defined(CONFIG_ARMADA_XP)) +#elif (defined(CONFIG_KIRKWOOD) || defined(CONFIG_ARCH_MVEBU)) #include #elif defined(CONFIG_SUNXI) #include -- cgit v1.3.1