From d9be8606bb983db398a7444533a72e3e4eabe011 Mon Sep 17 00:00:00 2001 From: Tom Rini Date: Thu, 9 Sep 2021 07:54:49 -0400 Subject: arm: Remove aspenite board This board has not been converted to CONFIG_DM by the deadline. Remove it. As this is the last armada100 platform, remove that support as well. Cc: Prafulla Wadaskar Signed-off-by: Tom Rini --- drivers/gpio/Makefile | 1 - drivers/gpio/mvmfp.c | 55 -------------------------------------------------- drivers/mmc/mv_sdhci.c | 24 ---------------------- 3 files changed, 80 deletions(-) delete mode 100644 drivers/gpio/mvmfp.c (limited to 'drivers') diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index 18917488c21..a9dc546a20b 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -23,7 +23,6 @@ obj-$(CONFIG_IPROC_GPIO) += iproc_gpio.o obj-$(CONFIG_KIRKWOOD_GPIO) += kw_gpio.o obj-$(CONFIG_KONA_GPIO) += kona_gpio.o obj-$(CONFIG_MARVELL_GPIO) += mvgpio.o -obj-$(CONFIG_MARVELL_MFP) += mvmfp.o obj-$(CONFIG_MCP230XX_GPIO) += mcp230xx_gpio.o obj-$(CONFIG_MXC_GPIO) += mxc_gpio.o obj-$(CONFIG_MXS_GPIO) += mxs_gpio.o diff --git a/drivers/gpio/mvmfp.c b/drivers/gpio/mvmfp.c deleted file mode 100644 index 511042c1990..00000000000 --- a/drivers/gpio/mvmfp.c +++ /dev/null @@ -1,55 +0,0 @@ -// SPDX-License-Identifier: GPL-2.0+ -/* - * (C) Copyright 2010 - * Marvell Semiconductor - * Written-by: Prafulla Wadaskar , - */ - -#include -#include -#include -#include - -/* - * mfp_config - * - * On most of Marvell SoCs (ex. ARMADA100) there is Multi-Funtion-Pin - * configuration registers to configure each GPIO/Function pin on the - * SoC. - * - * This function reads the array of values for - * MFPR_X registers and programms them into respective - * Multi-Function Pin registers. - * It supports - Alternate Function Selection programming. - * - * Whereas, - * The Configureation value is constructed using MFP() - * array consists of 32bit values as defined in MFP(xx,xx..) macro - */ -void mfp_config(u32 *mfp_cfgs) -{ - u32 *p_mfpr = NULL; - u32 cfg_val, val; - - do { - cfg_val = *mfp_cfgs++; - /* exit if End of configuration table detected */ - if (cfg_val == MFP_EOC) - break; - - p_mfpr = (u32 *)(MV_MFPR_BASE - + MFP_REG_GET_OFFSET(cfg_val)); - - /* Write a mfg register as per configuration */ - val = 0; - if (cfg_val & MFP_VALUE_MASK) - val |= cfg_val & MFP_VALUE_MASK; - - writel(val, p_mfpr); - } while (1); - /* - * perform a read-back of any MFPR register to make sure the - * previous writings are finished - */ - readl(p_mfpr); -} diff --git a/drivers/mmc/mv_sdhci.c b/drivers/mmc/mv_sdhci.c index 591137f50e3..336ebf14102 100644 --- a/drivers/mmc/mv_sdhci.c +++ b/drivers/mmc/mv_sdhci.c @@ -44,29 +44,6 @@ static void sdhci_mvebu_mbus_config(void __iomem *base) #ifdef CONFIG_MMC_SDHCI_IO_ACCESSORS static struct sdhci_ops mv_ops; - -#if defined(CONFIG_SHEEVA_88SV331xV5) -#define SD_CE_ATA_2 0xEA -#define MMC_CARD 0x1000 -#define MMC_WIDTH 0x0100 -static inline void mv_sdhci_writeb(struct sdhci_host *host, u8 val, int reg) -{ - struct mmc *mmc = host->mmc; - u32 ata = (unsigned long)host->ioaddr + SD_CE_ATA_2; - - if (!IS_SD(mmc) && reg == SDHCI_HOST_CONTROL) { - if (mmc->bus_width == 8) - writew(readw(ata) | (MMC_CARD | MMC_WIDTH), ata); - else - writew(readw(ata) & ~(MMC_CARD | MMC_WIDTH), ata); - } - - writeb(val, host->ioaddr + reg); -} - -#else -#define mv_sdhci_writeb NULL -#endif /* CONFIG_SHEEVA_88SV331xV5 */ #endif /* CONFIG_MMC_SDHCI_IO_ACCESSORS */ int mv_sdh_init(unsigned long regbase, u32 max_clk, u32 min_clk, u32 quirks) @@ -84,7 +61,6 @@ int mv_sdh_init(unsigned long regbase, u32 max_clk, u32 min_clk, u32 quirks) host->max_clk = max_clk; #ifdef CONFIG_MMC_SDHCI_IO_ACCESSORS memset(&mv_ops, 0, sizeof(struct sdhci_ops)); - mv_ops.write_b = mv_sdhci_writeb; host->ops = &mv_ops; #endif -- cgit v1.2.3