| Age | Commit message (Collapse) | Author |
|---|
|
The per-edit disclosure named the product and model, so every agent and every
model version appended another line. 74 files carried two to four of them, and
the same five products had accumulated 13 spellings -- Copilot against GitHub
Copilot, Claude Sonnet 4.6 against claude-sonnet-4.6, four spellings of Codex.
Twenty assembly lines carried a doubled comment marker, `; //` or `@ //`.
Every file now carries exactly one line, fixed text naming no product:
Portions of this file were generated with AI assistance.
It is written with the comment character that file already uses, so the `;`
and `@` assembly files keep theirs and the doubled markers are gone. Precise
attribution stays on the commit, where the Assisted-by trailer is per-change,
dated and attached to the diff it describes. A header line cannot hold that
record honestly, because the code it names gets rewritten and the line stays.
A file-level flag answers whether; the history answers who.
Comment-only. 455 files, 455 insertions and 574 deletions: every removed line
was a disclosure line, every added line is the fixed text, and no file is left
with zero or with more than one. `scripts/check_ports.sh` passes, including the
reproducibility check that would catch a ports_arch master and its generated
copies drifting apart. Recompiled against dev, every file that builds without a
vendor toolchain gives a byte-identical object: 19 of 19 C files under common,
100 of 100 GNU assembly files, and all 16 assemblable files whose comment
marker changed. The 10 remaining marker changes are ac5 and IAR sources where
`;` already started the comment and only the redundant `//` was removed.
Assisted-by: Claude Code (Opus 5) <[email protected]>
|
|
the Cortex-M low-level initialization (#714)
_tx_initialize_low_level wrote VTOR and derived _tx_thread_system_stack_ptr from
the reset vector on every Cortex-M port. Programming VTOR is the job of the
low-level startup code that runs before the kernel is entered, and doing it again
inside ThreadX silently overrode a vector table that the application, a
bootloader or a firmware update had already installed. It also forced every
application to export a vector table symbol that the kernel itself never needed.
_tx_thread_system_stack_ptr is never read by any Cortex-M port, so the value
copied out of the reset vector served no purpose.
Both blocks are removed from all Cortex-M ports, together with the now-unused
symbol declarations. The GreenHills files keep the NVIC base address load that
the removed block used to leave in r0 for the SysTick setup that follows.
Applications that relied on ThreadX programming VTOR must now set it in their
startup code. The bundled examples link their vector table at address zero and
run on the reset default.
Fixes #370
Assisted-by: Copilot (Opus 5) <[email protected]>
|
|
(#711)
The idle loop in _tx_thread_schedule masks interrupts before re-reading
_tx_thread_execute_ptr, so that an interrupt cannot make a thread ready
between that read and the WFI and then be lost. With PRIMASK that is safe:
the architecture excludes PRIMASK from the WFI wake-up condition, so the
interrupt still wakes the processor and is taken as soon as the loop
re-enables interrupts.
BASEPRI is not excluded. When TX_PORT_USE_BASEPRI is defined, the mask
written at the top of the loop is still in place at the WFI, so any
interrupt at or below TX_PORT_BASEPRI fails to wake the processor at all.
On a system where every interrupt is managed by ThreadX, that is every
interrupt, and the processor stays in WFI or in the low power mode entered
by tx_low_power_enter until something outside the mask happens.
Set PRIMASK and clear BASEPRI for the duration of the WFI, then restore
BASEPRI and clear PRIMASK. Interrupts remain masked across the whole
window, so the original race is still closed, but the wake-up condition is
now evaluated with BASEPRI clear and any enabled interrupt can end the wait.
A pending interrupt is taken at the CPSIE i, or at the existing unmask
further down the loop if it falls below TX_PORT_BASEPRI.
The change is made in the ARMv7-M and ARMv8-M sources under ports_arch,
including the module manager, and propagated to the generated ports with
the copy scripts. The ghs and keil ports do not implement
TX_PORT_USE_BASEPRI, and Cortex-M0/M0+/M23 have no BASEPRI register, so
those ports are unaffected.
Verified by assembling every patched GNU port for Cortex-M3, M4, M7, M33,
M55 and M85, with and without TX_PORT_USE_BASEPRI, TX_LOW_POWER and
TX_ENABLE_EXECUTION_CHANGE_NOTIFY, and by checking the disassembly of the
idle loop.
Fixes #279
Assisted-by: Copilot (Opus 5) <[email protected]>
|
|
The BASEPRI-masking path in tx_thread_schedule wrote "MOV r0, 0" rather
than "MOV r0, #0". UAL requires the "#" prefix on an immediate operand.
GNU as and the LLVM-based assemblers accept the unprefixed form and emit
the intended encoding, but stricter assemblers reject it outright, so the
affected ports could not be built with those toolchains.
The GNU and AC6 sources had already been corrected; this brings the IAR
and AC5 sources into line. Verified that both spellings assemble to the
same Thumb-2 encoding (f04f 0000), so this is a source-correctness fix
with no change in generated code or runtime behaviour.
Covers 31 occurrences across the Cortex-M3, M4, M7, M33, M52, M55 and M85
ports, their module manager counterparts, and the shared ARMv7-M and
ARMv8-M architecture sources.
Fixes #461
Assisted-by: Copilot (Opus 5) <[email protected]>
|
|
* Add SysTick counter reset in Cortex-M ports
The SysTick counter value (SYST_CVR @0xE000E018) is indeterminate after
reset. Without clearing it prior to enabling the counter, the first tick
interval becomes unpredictable.
* Fixed missing comment and added generated-by header in Cortex-M0/AC6 port
Added the missing inline comment on the LDR r1, =0 instruction
(Build value for SysTick reset) and the required AI-generated
attribution comment under the copyright header.
---------
Co-authored-by: Frédéric Desbiens <[email protected]>
Co-authored-by: Copilot <[email protected]>
|
|
Applied the standard MIT license header to all project-owned C, header,
assembly, shell, and Python files that were missing a copyright notice.
Third-party, toolchain startup, and auto-generated files were excluded.
Co-authored-by: Copilot <[email protected]>
|
|
* Updated version number constants
* Removed revision history from all files
* Added Eclipse ThreadX contributors' copyright header
|
|
|
|
|
|
* Include tx_user.h in ARMv7-M IAR port
* Include tx_user.h in ARMv7-M AC5 port
* Include tx_user.h in cortex_m3/4/7 IAR and AC5 port
|
|
* Release ARMv7-M and ARMv8-M architecture ports
* Add a pipeline to check ports_arch
|
