increase version for release

along with minor doc update

1 files changed, 9 insertions, 10 deletions

diff --git a/docs/reference/getting_started.rst b/docs/reference/getting_started.rst
index 1088d4700..3cdb46849 100644
--- a/docs/reference/getting_started.rst
+++ b/docs/reference/getting_started.rst
@@ -50,16 +50,7 @@ Some TinyUSB examples also requires external submodule libraries in ``/lib`` suc
 
    $ git submodule update --init lib
 
-In addition, MCU driver submodule is also needed to provide low-level MCU peripheral's driver. To download these depencies for your board, run the ``get-dpes`` as follow.
-
-.. code-block::
-
-   $ make BOARD=feather_nrf52840_express get-deps
-
-
-Some modules will also require a module-specific SDK (e.g. RP2040) or binary (e.g. Sony Spresense) to build examples.
-
-Note: some examples especially those that uses Vendor class (e.g webUSB) may requires udev permission on Linux (and/or macOS) to access usb device. It depends on your OS distro, typically copy ``/examples/device/99-tinyusb.rules`` file to /etc/udev/rules.d/ then run ``sudo udevadm control --reload-rules && sudo udevadm trigger`` is good enough.
+Some ports will also require a port-specific SDK (e.g. RP2040) or binary (e.g. Sony Spresense) to build examples. They are out of scope for tinyusb, you should download/install it first according to its manufacturer guide. 
 
 Build
 ^^^^^
@@ -70,6 +61,13 @@ To build example, first change directory to an example folder.
 
    $ cd examples/device/cdc_msc
 
+Before building, we need to download MCU driver submodule to provide low-level MCU peripheral's driver first. Run the ``get-dpes`` target in one of the example folder as follow. You only need to do this once per mcu
+
+.. code-block::
+
+   $ make BOARD=feather_nrf52840_express get-deps
+
+
 Some modules (e.g. RP2040 and ESP32s2) require the project makefiles to be customized using CMake. If necessary apply any setup steps for the platform's SDK.
 
 Then compile with ``make BOARD=[board_name] all``\ , for example
@@ -79,6 +77,7 @@ Then compile with ``make BOARD=[board_name] all``\ , for example
    $ make BOARD=feather_nrf52840_express all
 
 Note: ``BOARD`` can be found as directory name in ``hw/bsp``\ , either in its family/boards or directly under bsp (no family).
+Note: some examples especially those that uses Vendor class (e.g webUSB) may requires udev permission on Linux (and/or macOS) to access usb device. It depends on your OS distro, typically copy ``/examples/device/99-tinyusb.rules`` file to /etc/udev/rules.d/ then run ``sudo udevadm control --reload-rules && sudo udevadm trigger`` is good enough.
 
 Port Selection
 ~~~~~~~~~~~~~~