rusb2: EP0 OUT reliability, HS UTMI PHY power-up, FS-only build support

- EP0 OUT: park a back-to-back data-stage packet the DCP accepted before
  PID could go NAK and deliver it into the next armed chunk; flow-control
  the single-buffer control pipe between chunks (usbtest ctrl_out
  corruption); discard a packet parked while an OUT pipe was halted so
  BOT reset recovery's fresh CBW read can't receive stale WRITE data
- HS UTMI PHY power-up per the FSP sequence, shared by dcd/hcd: CLKSEL
  programmed from the board XTAL (EK-RA8M1 runs 20 MHz; the 24 MHz reset
  default never locks) while DIRPD holds the PHY down, then timed release
- hw/bsp(ra8m1_ek): fix U60CK divider macro - BSP_CFG_U60CK_DIV used the
  generic USB_CLOCK_DIV_8 encoding (7), which USB60CKDIVCR rejects,
  leaving the USBHS link domain at 480 MHz; the USB60-specific
  BSP_CLOCKS_USB60_CLOCK_DIV_8 (4) sticks and yields the required 60 MHz
  from PLL1P
- support FS-only builds on the high-speed port: gate SYSCFG.HSE on
  TUD_OPT_HIGH_SPEED (RHPORT_DEVICE_SPEED=OPT_MODE_FULL_SPEED was a
  silent no-op) and always compile both hwfifo access widths - the FIFO
  width belongs to the module, not the link speed (FS builds corrupted
  odd-length tails: 16-bit access against MBW-32)
- iso activate: reset stale pipe bookkeeping so a BRDY firing before the
  class re-arms can't replay a pre-SET_INTERFACE transfer; write PIPEBUF
  after PIPESEL selects the pipe (PIPESEL-windowed register)
- clear-halt: re-assert BUF on a still-armed OUT pipe (usbtest case 29)
- bound the D0FIFO ready spin so an undrained double-buffered IN pipe
  can't freeze the stack with the IRQ masked
- usbtest example: cap interrupt mps at 64 on RUSB2 high speed (pipes
  6-9 have a fixed 64-byte buffer, RA6M5 UM 29.1)

Verified: usbtest 30/30 on ra6m5_ek (HS), ra4m1_ek (FS) and ra8m1_ek
(FS-forced build on the HS port).

Co-Authored-By: Claude Fable 5 <[email protected]>
Claude-Session: https://claude.ai/code/session_01HeF2gZ1M7GWkz6Av4BpKPg

0 files changed, 0 insertions, 0 deletions