dcd_set_address include status response, usbd control stall both control in and out

1 files changed, 7 insertions, 3 deletions

diff --git a/src/device/dcd.h b/src/device/dcd.h
index abd85a70b..46c11ff1c 100644
--- a/src/device/dcd.h
+++ b/src/device/dcd.h
@@ -94,10 +94,16 @@ TU_VERIFY_STATIC(sizeof(dcd_event_t) <= 12, "size is not correct");
  *------------------------------------------------------------------*/

 bool dcd_init       (uint8_t rhport);

 

+// Enable device interrupt

 void dcd_int_enable (uint8_t rhport);

+

+// Disable device interrupt

 void dcd_int_disable(uint8_t rhport);

 

+// Receive Set Address request, mcu port must also include status IN response

 void dcd_set_address(uint8_t rhport, uint8_t dev_addr);

+

+// Receive Set Config request

 void dcd_set_config (uint8_t rhport, uint8_t config_num);

 

 // Get current frame number

@@ -118,15 +124,13 @@ void dcd_event_setup_received(uint8_t rhport, uint8_t const * setup, bool in_isr
 // helper to send transfer complete event

 void dcd_event_xfer_complete (uint8_t rhport, uint8_t ep_addr, uint32_t xferred_bytes, uint8_t result, bool in_isr);

 

-

 /*------------------------------------------------------------------*/

 /* Endpoint API

  *  - open        : Configure endpoint's registers

  *  - xfer        : Submit a transfer. When complete dcd_event_xfer_complete

  *                  must be called to notify the stack

  *  - busy        : Check if endpoint transferring is complete (TODO remove)

- *  - stall       : stall ep. When control endpoint (addr = 0) is stalled,

- *                  both direction (IN & OUT) of control ep must be stalled.

+ *  - stall       : stall endpoint

  *  - clear_stall : clear stall

  *  - stalled     : check if stalled ( TODO remove )

  *------------------------------------------------------------------*/