diff options
Diffstat (limited to '.claude/skills/usb-target-debug')
| -rw-r--r-- | .claude/skills/usb-target-debug/SKILL.md | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/.claude/skills/usb-target-debug/SKILL.md b/.claude/skills/usb-target-debug/SKILL.md index c664bf8fc..71fac98f2 100644 --- a/.claude/skills/usb-target-debug/SKILL.md +++ b/.claude/skills/usb-target-debug/SKILL.md @@ -58,7 +58,7 @@ Build with `LOG=2` (`LOG=3` adds per-transfer noise and much more timing skew). `LOGGER=rtt` routes it over the debug probe (J-Link only) — no UART wiring: ```bash -# RTT: JLinkGDBServer from AGENTS.md "GDB Debugging" + -RTTTelnetPort, then: +# RTT: JLinkGDBServer from CLAUDE.md "GDB Debugging" + -RTTTelnetPort, then: timeout 20s JLinkRTTClient > /tmp/rtt.log # non-interactive capture # UART (board's debug serial, if wired): stty -F /dev/ttyACM<N> 115200 raw && timeout 20s cat /dev/ttyACM<N> | tee /tmp/uart.log @@ -80,10 +80,10 @@ reads don't halt the target. ## GDB — state autopsy and watchpoints Connect/load recipes per probe family (J-Link, OpenOCD for ST-Link / -CMSIS-DAP / WCH-Link) are in AGENTS.md "GDB Debugging". Release builds keep +CMSIS-DAP / WCH-Link) are in CLAUDE.md "GDB Debugging". Release builds keep DWARF (`MinSizeRel`), so `p`/struct access works on HIL firmware. -**Autopsy of a wedged board: attach and halt ONLY** — skip AGENTS.md's +**Autopsy of a wedged board: attach and halt ONLY** — skip CLAUDE.md's `monitor reset halt` + `load` (those are for fresh starts; a reset destroys the evidence). Symbolize with the ELF that is actually flashed — `<build root>/cmake-build-<board>/<example>/<example>.elf` from the run that |