diff options
Diffstat (limited to 'src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c')
| -rw-r--r-- | src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c | 22 |
1 files changed, 2 insertions, 20 deletions
diff --git a/src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c b/src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c index 135b4e8f6..41da3ddd0 100644 --- a/src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c +++ b/src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c @@ -393,26 +393,8 @@ void dcd_int_handler(uint8_t rhport) { const uint32_t ep_reg = ep_read(ep_id); if (ep_reg & U_EP_CTR_RX) { - #ifdef CFG_TUSB_FSDEV_32BIT - /* https://www.st.com/resource/en/errata_sheet/es0561-stm32h503cbebkbrb-device-errata-stmicroelectronics.pdf - * https://www.st.com/resource/en/errata_sheet/es0587-stm32u535xx-and-stm32u545xx-device-errata-stmicroelectronics.pdf - * From H503/U535 errata: Buffer description table update completes after CTR interrupt triggers - * Description: - * - During OUT transfers, the correct transfer interrupt (CTR) is triggered a little before the last USB SRAM - * accesses have completed. If the software responds quickly to the interrupt, the full buffer contents may not be - * correct. Workaround: - * - Software should ensure that a small delay is included before accessing the SRAM contents. This delay - * should be 800 ns in Full Speed mode and 6.4 μs in Low Speed mode - * - Since H5 can run up to 250Mhz -> 1 cycle = 4ns. Per errata, we need to wait 200 cycles. Though executing code - * also takes time, so we'll wait 60 cycles (count = 20). - * - Since Low Speed mode is not supported/popular, we will ignore it for now. - * - * Note: this errata may also apply to G0, U5, H5 etc. - */ - volatile uint32_t cycle_count = 20; // defined as PCD_RX_PMA_CNT in stm32 hal_driver - while (cycle_count > 0U) { - cycle_count--; // each count take 3 cycles (1 for sub, jump, and compare) - } + #if defined(TUP_USBIP_FSDEV_STM32) && defined(CFG_TUSB_FSDEV_32BIT) + fsdev_btable_workaround_delay(false); #endif if (ep_reg & U_EP_SETUP) { |