Merge branch 'master' of git://git.denx.de/u-boot-arm

1 files changed, 13 insertions, 8 deletions

diff --git a/README b/README
index a3364762376..d8cb3940d4f 100644
--- a/README
+++ b/README
@@ -2819,6 +2819,12 @@ FIT uImage format:
 		CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME
 		Filename to read to load U-Boot when reading from FAT
 
+		CONFIG_SPL_MPC83XX_WAIT_FOR_NAND
+		Set this for NAND SPL on PPC mpc83xx targets, so that
+		start.S waits for the rest of the SPL to load before
+		continuing (the hardware starts execution after just
+		loading the first page rather than the full 4K).
+
 		CONFIG_SPL_NAND_BASE
 		Include nand_base.c in the SPL.  Requires
 		CONFIG_SPL_NAND_DRIVERS.
@@ -2876,6 +2882,10 @@ FIT uImage format:
 		CONFIG_SPL_LIBGENERIC_SUPPORT
 		Support for lib/libgeneric.o in SPL binary
 
+		CONFIG_SPL_PAD_TO
+		Linker address to which the SPL should be padded before
+		appending the SPL payload.
+
 		CONFIG_SPL_TARGET
 		Final target image containing SPL and payload.  Some SPLs
 		use an arch-specific makefile fragment instead, for
@@ -3806,14 +3816,9 @@ Low Level (hardware related) configuration options:
 		be used if available. These functions may be faster under some
 		conditions but may increase the binary size.
 
-- CONFIG_X86_NO_RESET_VECTOR
-		If defined, the x86 reset vector code is excluded. You will need
-		to do this when U-Boot is running from Coreboot.
-
-- CONFIG_X86_NO_REAL_MODE
-		If defined, x86 real mode code is omitted. This assumes a
-		32-bit environment where such code is not needed. You will
-		need to do this when U-Boot is running from Coreboot.
+- CONFIG_X86_RESET_VECTOR
+		If defined, the x86 reset vector code is included. This is not
+		needed when U-Boot is running from Coreboot.
 
 
 Freescale QE/FMAN Firmware Support: