sunxi: Fix gmac not working due to cpu_eth_init no longer being called

cpu_eth_init is no longer called for dm enabled eth drivers, this
was causing the sunxi gmac eth controller to no longer work in u-boot.

This commit fixes this by calling the clock, reset and pinmux setup
function from s_init() and enabling the phy power pin (if any) from
board_init().

The enabling of phy power cannot be done from s_init because it uses dm
and dm is not ready yet at this point.

Note that the mdelay is dropped as the phy gets enabled much earlier
now, so it is no longer needed.

Signed-off-by: Hans de Goede <[email protected]>
Acked-by: Ian Campbell <[email protected]>
Tested-by: Karsten Merker <[email protected]>
Tested-by: Michael Haas <[email protected]>

1 files changed, 1 insertions, 27 deletions

diff --git a/arch/arm/cpu/armv7/sunxi/board.c b/arch/arm/cpu/armv7/sunxi/board.c
index e80785ba566..7653148c67e 100644
--- a/arch/arm/cpu/armv7/sunxi/board.c
+++ b/arch/arm/cpu/armv7/sunxi/board.c
@@ -152,6 +152,7 @@ void s_init(void)
 	timer_init();
 	gpio_init();
 	i2c_init_board();
+	eth_init_board();
 }
 
 #ifdef CONFIG_SPL_BUILD
@@ -259,30 +260,3 @@ void enable_caches(void)
 	dcache_enable();
 }
 #endif
-
-#ifdef CONFIG_CMD_NET
-/*
- * Initializes on-chip ethernet controllers.
- * to override, implement board_eth_init()
- */
-int cpu_eth_init(bd_t *bis)
-{
-	__maybe_unused int rc;
-
-#ifdef CONFIG_MACPWR
-	gpio_request(CONFIG_MACPWR, "macpwr");
-	gpio_direction_output(CONFIG_MACPWR, 1);
-	mdelay(200);
-#endif
-
-#ifdef CONFIG_SUNXI_GMAC
-	rc = sunxi_gmac_initialize(bis);
-	if (rc < 0) {
-		printf("sunxi: failed to initialize gmac\n");
-		return rc;
-	}
-#endif
-
-	return 0;
-}
-#endif