serial: msm: Re-enable after resetting

The documentation for the UART controller in the APQ8016E specifies that
both RESET and ENABLE commands must be issued to set up the receiver and
transmitter, but at the moment we only issue RESET. This doesn't seem to
cause issues in practice (looks like the reset already re-enables the
receiver/transmitter), but let's add the two writes to RX_ENABLE/TX_ENABLE
to better match the recommendations in the documentation.

Reviewed-by: Neil Armstrong <[email protected]>
Signed-off-by: Stephan Gerhold <[email protected]>
Tested-by: Alexey Minnekhanov <[email protected]>
Acked-by: Sumit Garg <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Casey Connolly <[email protected]>

0 files changed, 0 insertions, 0 deletions