Merge tag 'xilinx-for-v2019.07' of git://git.denx.de/u-boot-microblaze

Xilinx/FPGA changes for v2019.07

fpga:
- Add support for external data in FIT
- Extend testing for external data case
- Inform user about a need to run post config on Zynq

arm:
- Tune zynq command functions
- Fix internal variable setting

arm64:
- Add support for zc39dr decoding
- Disable WDT for zcu100
- Small changes in reset_reason()
- Some DT changes (spi)
- Tune qspi-mini configuration
- Remove useless eeprom setting
- Fix two sdhci boot case

spi:
- Fix tap delay programming

clk:
- Enable i2c in SPL

net:
- Fix gem phydev handling
- Remove phy detection code from gem driver

general:
- Correct EXT_DTB usage for MULTI_DTB_FIT configuration

4 files changed, 11 insertions, 53 deletions

diff --git a/drivers/clk/clk_zynq.c b/drivers/clk/clk_zynq.c
index 482f0937cb5..b09c37db40f 100644
--- a/drivers/clk/clk_zynq.c
+++ b/drivers/clk/clk_zynq.c
@@ -434,6 +434,8 @@ static ulong zynq_clk_get_rate(struct clk *clk)
 	case lqspi_clk ... pcap_clk:
 	case sdio0_clk ... spi1_clk:
 		return zynq_clk_get_peripheral_rate(priv, id, 0);
+	case i2c0_aper_clk ... i2c1_aper_clk:
+		return zynq_clk_get_cpu_rate(priv, cpu_1x_clk);
 	default:
 		return -ENXIO;
 	}
diff --git a/drivers/fpga/zynqpl.c b/drivers/fpga/zynqpl.c
index 499310d0c0b..069c63ba456 100644
--- a/drivers/fpga/zynqpl.c
+++ b/drivers/fpga/zynqpl.c
@@ -408,6 +408,8 @@ static int zynq_load(xilinx_desc *desc, const void *buf, size_t bsize,
 	if (bstype != BIT_PARTIAL)
 		zynq_slcr_devcfg_enable();
 
+	puts("INFO:post config was not run, please run manually if needed\n");
+
 	return FPGA_SUCCESS;
 }
 
@@ -421,7 +423,8 @@ static int zynq_loadfs(xilinx_desc *desc, const void *buf, size_t bsize,
 	loff_t blocksize, actread;
 	loff_t pos = 0;
 	int fstype;
-	char *interface, *dev_part, *filename;
+	char *interface, *dev_part;
+	const char *filename;
 
 	blocksize = fsinfo->blocksize;
 	interface = fsinfo->interface;
diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 3bd0093b7ab..033efb81956 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -261,45 +261,6 @@ static int phywrite(struct zynq_gem_priv *priv, u32 phy_addr,
 			    ZYNQ_GEM_PHYMNTNC_OP_W_MASK, &data);
 }
 
-static int phy_detection(struct udevice *dev)
-{
-	int i;
-	u16 phyreg = 0;
-	struct zynq_gem_priv *priv = dev->priv;
-
-	if (priv->phyaddr != -1) {
-		phyread(priv, priv->phyaddr, PHY_DETECT_REG, &phyreg);
-		if ((phyreg != 0xFFFF) &&
-		    ((phyreg & PHY_DETECT_MASK) == PHY_DETECT_MASK)) {
-			/* Found a valid PHY address */
-			debug("Default phy address %d is valid\n",
-			      priv->phyaddr);
-			return 0;
-		} else {
-			debug("PHY address is not setup correctly %d\n",
-			      priv->phyaddr);
-			priv->phyaddr = -1;
-		}
-	}
-
-	debug("detecting phy address\n");
-	if (priv->phyaddr == -1) {
-		/* detect the PHY address */
-		for (i = 31; i >= 0; i--) {
-			phyread(priv, i, PHY_DETECT_REG, &phyreg);
-			if ((phyreg != 0xFFFF) &&
-			    ((phyreg & PHY_DETECT_MASK) == PHY_DETECT_MASK)) {
-				/* Found a valid PHY address */
-				priv->phyaddr = i;
-				debug("Found valid phy address, %d\n", i);
-				return 0;
-			}
-		}
-	}
-	printf("PHY is not detected\n");
-	return -1;
-}
-
 static int zynq_gem_setup_mac(struct udevice *dev)
 {
 	u32 i, macaddrlow, macaddrhigh;
@@ -345,28 +306,20 @@ static int zynq_phy_init(struct udevice *dev)
 	/* Enable only MDIO bus */
 	writel(ZYNQ_GEM_NWCTRL_MDEN_MASK, &regs->nwctrl);
 
-	if ((priv->interface != PHY_INTERFACE_MODE_SGMII) &&
-	    (priv->interface != PHY_INTERFACE_MODE_GMII)) {
-		ret = phy_detection(dev);
-		if (ret) {
-			printf("GEM PHY init failed\n");
-			return ret;
-		}
-	}
-
 	priv->phydev = phy_connect(priv->bus, priv->phyaddr, dev,
 				   priv->interface);
 	if (!priv->phydev)
 		return -ENODEV;
 
-	priv->phydev->supported &= supported | ADVERTISED_Pause |
-				  ADVERTISED_Asym_Pause;
 	if (priv->max_speed) {
 		ret = phy_set_supported(priv->phydev, priv->max_speed);
 		if (ret)
 			return ret;
 	}
 
+	priv->phydev->supported &= supported | ADVERTISED_Pause |
+				  ADVERTISED_Asym_Pause;
+
 	priv->phydev->advertising = priv->phydev->supported;
 	priv->phydev->node = priv->phy_of_node;
 
diff --git a/drivers/spi/zynqmp_gqspi.c b/drivers/spi/zynqmp_gqspi.c
index da9413c0661..04ea42cbccc 100644
--- a/drivers/spi/zynqmp_gqspi.c
+++ b/drivers/spi/zynqmp_gqspi.c
@@ -267,7 +267,7 @@ void zynqmp_qspi_set_tapdelay(struct udevice *bus, u32 baudrateval)
 		zynqmp_mmio_read(IOU_TAPDLY_BYPASS_OFST, &tapdlybypass);
 		tapdlybypass |= (TAP_DLY_BYPASS_LQSPI_RX_VALUE <<
 				TAP_DLY_BYPASS_LQSPI_RX_SHIFT);
-	} else if (reqhz < GQSPI_FREQ_100MHZ) {
+	} else if (reqhz <= GQSPI_FREQ_100MHZ) {
 		zynqmp_mmio_read(IOU_TAPDLY_BYPASS_OFST, &tapdlybypass);
 		tapdlybypass |= (TAP_DLY_BYPASS_LQSPI_RX_VALUE <<
 				TAP_DLY_BYPASS_LQSPI_RX_SHIFT);
@@ -277,7 +277,7 @@ void zynqmp_qspi_set_tapdelay(struct udevice *bus, u32 baudrateval)
 		datadlyadj |= ((GQSPI_USE_DATA_DLY << GQSPI_USE_DATA_DLY_SHIFT)
 				| (GQSPI_DATA_DLY_ADJ_VALUE <<
 					GQSPI_DATA_DLY_ADJ_SHIFT));
-	} else if (reqhz < GQSPI_FREQ_150MHZ) {
+	} else if (reqhz <= GQSPI_FREQ_150MHZ) {
 		lpbkdlyadj = readl(&regs->lpbkdly);
 		lpbkdlyadj |= ((GQSPI_LPBK_DLY_ADJ_LPBK_MASK) |
 				GQSPI_LPBK_DLY_ADJ_DLY_0);