mmc: tmio: sdhi: HS400 manual adjustment

Since Gen3 SDHI has an internal DS signal AC-spec violation in HS400 mode,
CRC-error may occur in read command in HS400 mode. This phoenomenon occurs
at low/high temperature.

To fix this, after completion of HS400 tuning, enable manual calibration.
However, Gen3 M3 Ver.1.2 or earlier and H3 1.x does not support HS400.
These SoC forcibly use HS200 mode by SoC attribute.

The DT adjustment of the tuning parameters is not supported until the
DT property names become clear.

Signed-off-by: Marek Vasut <[email protected]>
Adapted from a patch by Takeshi Saito <[email protected]>
Cc: Nobuhiro Iwamatsu <[email protected]>
Cc: Peng Fan <[email protected]>

0 files changed, 0 insertions, 0 deletions