serial_bcm283x_mu: Flush RX queue after setting baud rate

After the UART was initialized, we may still have bogus data in the
RX queue if it was enabled with incorrect pin muxing before.

So let's flush the RX queue whenever we initialize baud rates.

This fixes a regression with the dynamic pinmuxing code when enable_uart=1
is not set in config.txt.

Fixes: caf2233b28 ("bcm283x: Add pinctrl driver")
Reported-by: Göran Lundberg <[email protected]>
Reported-by: Peter Robinson <[email protected]>
Signed-off-by: Alexander Graf <[email protected]>
Tested-by: Peter Robinson <[email protected]>
Tested-by: Tuomas Tynkkynen <[email protected]>

0 files changed, 0 insertions, 0 deletions