diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 32 |
1 files changed, 0 insertions, 32 deletions
@@ -664,18 +664,6 @@ The following options need to be configured: CONFIG_SCSI) you must configure support for at least one non-MTD partition type as well. -- LBA48 Support - CONFIG_LBA48 - - Set this to enable support for disks larger than 137GB - Also look at CONFIG_SYS_64BIT_LBA. - Whithout these , LBA48 support uses 32bit variables and will 'only' - support disks up to 2.1TB. - - CONFIG_SYS_64BIT_LBA: - When enabled, makes the IDE subsystem use 64bit sector addresses. - Default is 32bit. - - NETWORK Support (PCI): CONFIG_E1000_SPI Utility code for direct access to the SPI bus on Intel 8257x. @@ -793,9 +781,6 @@ The following options need to be configured: Supported are USB Keyboards and USB Floppy drives (TEAC FD-05PUB). - CONFIG_USB_EHCI_TXFIFO_THRESH enables setting of the - txfilltuning field in the EHCI controller on reset. - CONFIG_USB_DWC2_REG_ADDR the physical CPU address of the DWC2 HW module registers. @@ -1365,10 +1350,6 @@ The following options need to be configured: Enables support for FPGA family. (SPARTAN2, SPARTAN3, VIRTEX2, CYCLONE2, ACEX1K, ACEX) - CONFIG_FPGA_COUNT - - Specify the number of FPGA devices to support. - CONFIG_SYS_FPGA_PROG_FEEDBACK Enable printing of hash marks during FPGA configuration. @@ -1892,14 +1873,6 @@ Configuration Settings: while unprotecting/erasing/programming. Please only enable this option if you really know what you are doing. -- CONFIG_ENV_MAX_ENTRIES - - Maximum number of entries in the hash table that is used - internally to store the environment settings. The default - setting is supposed to be generous and should work in most - cases. This setting can be used to tune behaviour; see - lib/hashtable.c for details. - - CONFIG_ENV_FLAGS_LIST_DEFAULT - CONFIG_ENV_FLAGS_LIST_STATIC Enable validation of the values given to environment variables when @@ -2179,11 +2152,6 @@ Low Level (hardware related) configuration options: proper). Code that needs stage-specific behavior should check this. -- CONFIG_SYS_MPC85XX_NO_RESETVEC - Only for 85xx systems. If this variable is specified, the section - .resetvec is not kept and the section .bootpg is placed in the - previous 4k of the .text section. - - CONFIG_ARCH_MAP_SYSMEM Generally U-Boot (and in particular the md command) uses effective address. It is therefore not necessary to regard |