diff options
Diffstat (limited to 'include')
| -rw-r--r-- | include/configs/ids8313.h | 237 |
1 files changed, 0 insertions, 237 deletions
diff --git a/include/configs/ids8313.h b/include/configs/ids8313.h deleted file mode 100644 index e89b800b7ee..00000000000 --- a/include/configs/ids8313.h +++ /dev/null @@ -1,237 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0+ */ -/* - * (C) Copyright 2013 - * Heiko Schocher, DENX Software Engineering, [email protected]. - * - * Based on: - * Copyright (c) 2011 IDS GmbH, Germany - * Sergej Stepanov <[email protected]> - */ - -#ifndef __CONFIG_H -#define __CONFIG_H - -#include <linux/stringify.h> - -/* - * High Level Configuration Options - */ - -#define CONFIG_SYS_SICRH 0x00000000 -#define CONFIG_SYS_SICRL (SICRL_LBC | SICRL_SPI_D) - -#define CONFIG_HWCONFIG - -/* - * Definitions for initial stack pointer and data area (in DCACHE ) - */ -#define CONFIG_SYS_INIT_RAM_LOCK -#define CONFIG_SYS_INIT_RAM_ADDR 0xFD000000 -#define CONFIG_SYS_INIT_RAM_SIZE 0x1000 /* End of used area in DPRAM */ - -/* - * Internal Definitions - */ -/* - * DDR Setup - */ -#define CONFIG_SYS_SDRAM_BASE 0x00000000 - -/* - * Manually set up DDR parameters, - * as this board has not the SPD connected to I2C. - */ -#define CONFIG_SYS_SDRAM_SIZE 0x10000000 /* 256 MiB */ -#define CONFIG_SYS_DDR_CONFIG (CSCONFIG_EN |\ - 0x00010000 |\ - CSCONFIG_ROW_BIT_13 |\ - CSCONFIG_COL_BIT_10) - -#define CONFIG_SYS_DDR_CONFIG_256 (CONFIG_SYS_DDR_CONFIG | \ - CSCONFIG_BANK_BIT_3) - -#define CONFIG_SYS_DDR_TIMING_3 (1 << 16) /* ext refrec */ -#define CONFIG_SYS_DDR_TIMING_0 ((3 << TIMING_CFG0_RWT_SHIFT) |\ - (3 << TIMING_CFG0_WRT_SHIFT) |\ - (3 << TIMING_CFG0_RRT_SHIFT) |\ - (3 << TIMING_CFG0_WWT_SHIFT) |\ - (6 << TIMING_CFG0_ACT_PD_EXIT_SHIFT) |\ - (2 << TIMING_CFG0_PRE_PD_EXIT_SHIFT) |\ - (8 << TIMING_CFG0_ODT_PD_EXIT_SHIFT) | \ - (2 << TIMING_CFG0_MRS_CYC_SHIFT)) -#define CONFIG_SYS_DDR_TIMING_1 ((4 << TIMING_CFG1_PRETOACT_SHIFT) |\ - (12 << TIMING_CFG1_ACTTOPRE_SHIFT) |\ - (4 << TIMING_CFG1_ACTTORW_SHIFT) |\ - (7 << TIMING_CFG1_CASLAT_SHIFT) |\ - (4 << TIMING_CFG1_REFREC_SHIFT) |\ - (4 << TIMING_CFG1_WRREC_SHIFT) |\ - (2 << TIMING_CFG1_ACTTOACT_SHIFT) |\ - (2 << TIMING_CFG1_WRTORD_SHIFT)) -#define CONFIG_SYS_DDR_TIMING_2 ((1 << TIMING_CFG2_ADD_LAT_SHIFT) |\ - (5 << TIMING_CFG2_CPO_SHIFT) |\ - (4 << TIMING_CFG2_WR_LAT_DELAY_SHIFT) |\ - (2 << TIMING_CFG2_RD_TO_PRE_SHIFT) |\ - (0 << TIMING_CFG2_WR_DATA_DELAY_SHIFT) |\ - (1 << TIMING_CFG2_CKE_PLS_SHIFT) |\ - (6 << TIMING_CFG2_FOUR_ACT_SHIFT)) - -#define CONFIG_SYS_DDR_INTERVAL ((0x800 << SDRAM_INTERVAL_REFINT_SHIFT) |\ - (0x800 << SDRAM_INTERVAL_BSTOPRE_SHIFT)) - -#define CONFIG_SYS_SDRAM_CFG (SDRAM_CFG_SREN |\ - SDRAM_CFG_2T_EN | SDRAM_CFG_HSE |\ - SDRAM_CFG_DBW_32 |\ - SDRAM_CFG_SDRAM_TYPE_DDR2) - -#define CONFIG_SYS_SDRAM_CFG2 0x00401000 -#define CONFIG_SYS_DDR_MODE ((0x0448 << SDRAM_MODE_ESD_SHIFT) |\ - (0x0242 << SDRAM_MODE_SD_SHIFT)) -#define CONFIG_SYS_DDR_MODE_2 0x00000000 -#define CONFIG_SYS_DDR_CLK_CNTL DDR_SDRAM_CLK_CNTL_CLK_ADJUST_075 -#define CONFIG_SYS_DDRCDR_VALUE (DDRCDR_EN |\ - DDRCDR_PZ_NOMZ |\ - DDRCDR_NZ_NOMZ |\ - DDRCDR_ODT |\ - DDRCDR_M_ODR |\ - DDRCDR_Q_DRN) - -/* - * on-board devices - */ -#define CONFIG_TSEC1 -#define CONFIG_TSEC2 - -/* - * NOR FLASH setup - */ -#define CONFIG_FLASH_SHOW_PROGRESS 50 - -#define CONFIG_SYS_FLASH_BASE 0xFF800000 -#define CONFIG_SYS_FLASH_SIZE 8 - -/* - * NAND FLASH setup - */ -#define CONFIG_SYS_NAND_BASE 0xE1000000 -#define CONFIG_SYS_MAX_NAND_DEVICE 1 -#define NAND_CACHE_PAGES 64 - - -/* - * MRAM setup - */ -#define CONFIG_SYS_MRAM_BASE 0xE2000000 -#define CONFIG_SYS_MRAM_SIZE 0x20000 /* 128 Kb */ - -/* - * CPLD setup - */ -#define CONFIG_SYS_CPLD_BASE 0xE3000000 - -/* - * HW-Watchdog - */ -#define CONFIG_SYS_WATCHDOG_VALUE 0xFFFF - -/* - * I2C setup - */ -#define CONFIG_SYS_I2C_RTC_ADDR 0x51 - -/* - * Ethernet setup - */ -#ifdef CONFIG_TSEC1 -#define CONFIG_TSEC1_NAME "TSEC0" -#define CONFIG_SYS_TSEC1_OFFSET 0x24000 -#define TSEC1_PHY_ADDR 0x1 -#define TSEC1_FLAGS TSEC_GIGABIT -#define TSEC1_PHYIDX 0 -#endif - -#ifdef CONFIG_TSEC2 -#define CONFIG_TSEC2_NAME "TSEC1" -#define TSEC2_PHY_ADDR 0x3 -#define TSEC2_FLAGS TSEC_GIGABIT -#define TSEC2_PHYIDX 0 -#endif - -/* - * Serial Port - */ -#define CONFIG_SYS_NS16550_SERIAL -#define CONFIG_SYS_NS16550_REG_SIZE 1 - -#define CONFIG_SYS_BAUDRATE_TABLE \ - {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 115200} -#define CONFIG_SYS_NS16550_COM1 (CONFIG_SYS_IMMR + 0x4500) -#define CONFIG_SYS_NS16550_COM2 (CONFIG_SYS_IMMR + 0x4600) -#define CONFIG_SYS_NS16550_CLK (get_bus_freq(0)) - -#define CONFIG_SYS_SCCR_USBDRCM 3 - -/* - * U-Boot environment setup - */ - -/* - * The reserved memory - */ -#define CONFIG_SYS_MONITOR_LEN (768 * 1024) - -/* - * Environment Configuration - */ - -#define CONFIG_NETDEV eth1 -#define CONFIG_HOSTNAME "ids8313" -#define CONFIG_ROOTPATH "/opt/eldk-4.2/ppc_6xx" -#define CONFIG_UBOOTPATH "ids8313/u-boot.bin" -#define CONFIG_FDTFILE "ids8313/ids8313.dtb" -#define CONFIG_ENV_FLAGS_LIST_STATIC "ethaddr:mo,eth1addr:mo" - -/* Initial Memory map for Linux*/ -#define CONFIG_SYS_BOOTMAPSZ (256 << 20) - -/* - * Miscellaneous configurable options - */ - -#define CONFIG_LOADS_ECHO -#undef CONFIG_SYS_LOADS_BAUD_CHANGE - -/* mtdparts command line support */ - -#define CONFIG_EXTRA_ENV_SETTINGS \ - "netdev=" __stringify(CONFIG_NETDEV) "\0" \ - "ethprime=TSEC1\0" \ - "uboot=" __stringify(CONFIG_UBOOTPATH) "\0" \ - "tftpflash=tftpboot ${loadaddr} ${uboot}; " \ - "protect off " __stringify(CONFIG_SYS_TEXT_BASE) \ - " +${filesize}; " \ - "erase " __stringify(CONFIG_SYS_TEXT_BASE) \ - " +${filesize}; " \ - "cp.b ${loadaddr} " __stringify(CONFIG_SYS_TEXT_BASE) \ - " ${filesize}; " \ - "protect on " __stringify(CONFIG_SYS_TEXT_BASE) \ - " +${filesize}; " \ - "cmp.b ${loadaddr} " __stringify(CONFIG_SYS_TEXT_BASE) \ - " ${filesize}\0" \ - "console=ttyS0\0" \ - "fdtaddr=0x780000\0" \ - "kernel_addr=ff800000\0" \ - "fdtfile=" __stringify(CONFIG_FDTFILE) "\0" \ - "setbootargs=setenv bootargs " \ - "root=${rootdev} rw console=${console}," \ - "${baudrate} ${othbootargs}\0" \ - "setipargs=setenv bootargs root=${rootdev} rw " \ - "nfsroot=${serverip}:${rootpath} " \ - "ip=${ipaddr}:${serverip}:${gatewayip}:" \ - "${netmask}:${hostname}:${netdev}:off " \ - "console=${console},${baudrate} ${othbootargs}\0" \ - "addmtd=setenv bootargs ${bootargs} ${mtdparts}\0" \ - "\0" - -/* UBI Support */ - -#endif /* __CONFIG_H */ |