| Age | Commit message (Collapse) | Author |
|---|
|
Board specific READMEs should be located inside the respective board directory.
Signed-off-by: Fabio Estevam <[email protected]>
|
|
Create a README.mxs file that contains instructions on how to use U-boot for
both MX23 and MX28.
As boot from NAND has only been tested on mx28, make it clear that it only
applies to MX28.
While at it, do some small cleanups for the sake of consistency:
- Use "MX28" instead of "i.MX28"
- Use "section" instead of "chapter" when referring to specific parts of the
reference manual chapters.
Signed-off-by: Fabio Estevam <[email protected]>
|
|
Introduce 'mx28evk_nand' target for saving environment variables into NAND.
The mx28evk board does not come with a NAND flash populated from the
factory. It comes with an empty slot (U23), which allows the insertion of a
48-pin TSOP flash device.
Tested with a K9LBG08U0D.
Signed-off-by: Fabio Estevam <[email protected]>
Reviewed-by: Otavio Salvador <[email protected]>
|
|
Most code can be shared between i.MX23 and i.MX28 as both are from
i.MXS family; this source directory structure makes easy to share code
among them.
Signed-off-by: Otavio Salvador <[email protected]>
Acked-by: Stefano Babic <[email protected]>
|
|
Fix the position for PSWITCH key.
The good benefit of doing this is that boot time is greatly reduced:
from 5 seconds to less then 1 second.
Signed-off-by: Fabio Estevam <[email protected]>
Acked-by: Marek Vasut <[email protected]>
|
|
Add a README file for mx28evk board.
Signed-off-by: Fabio Estevam <[email protected]>
Acked-by: Marek Vasut <[email protected]>
|
