| Age | Commit message (Collapse) | Author |
|---|
|
These boards have not been converted to CONFIG_DM_USB by the deadline
and is also missing conversion to CONFIG_DM. Remove them. As this is
the last of the SPEAr platforms, so remove the rest of the remaining
support as well.
Cc: Vipin Kumar <[email protected]>
Signed-off-by: Tom Rini <[email protected]>
|
|
This patch adds options for all the below mentioned configurations and
subsequently renames the include/configs/spearxxx.h files to spear3xx_evb.h,
spear6xx_evb.h etc to depict evaluation board configuration.
SPEAr3xx and SPEAr6xx boards can be compiled in following configurations
1. Environment placed in NAND
2. Console on usb device
3. Console on usb device with environment placed in NAND
4. SPEAr310 and SPEAr320 support environment variables in parallel
NOR flash.
Signed-off-by: Vipin Kumar <[email protected]>
Signed-off-by: Amit Virdi <[email protected]>
Signed-off-by: Stefan Roese <[email protected]>
|
|
ethaddr can be optionally read from i2c memory. So, chip_config command supports
reading/writing hw mac id into i2c memory. Placing this code within
CONFIG_CMD_NET as this would only be needed when network interface is configured
Signed-off-by: Vipin Kumar <[email protected]>
Signed-off-by: Amit Virdi <[email protected]>
Signed-off-by: Stefan Roese <[email protected]>
|
|
README.spear contains information about SPEAr architecture and
build options etc
Signed-off-by: Vipin <[email protected]>
|
