| Age | Commit message (Collapse) | Author |
|---|
|
This change allows to load boot image from the first SATA/SCSI device
partition and burn it to board boot location (e.g. SPI-NOR). This is
particularly when storage device is not handled by U-Boot as USB mass
storage (which is already supported by bubt) but as SATA/SCSI device.
Signed-off-by: Pali Rohár <[email protected]>
|
|
All 32-bit Armada SoCs and also 64-bit Armada 3720 SoC can load and boot
firmware from SATA disk. This adds support for updating firmware binary for
these SoCs. On 32-bit Armada SoC is firmware stored at sector 1 and on
Armada 3720 is stored at MBR partition 0x4d or GPT partition with type GUID
6828311A-BA55-42A4-BCDE-A89BB5EDECAE (Marvell Armada 3700 Boot partition).
Signed-off-by: Pali Rohár <[email protected]>
|
|
Support for burning into the correct eMMC HW boot partition was broken and
removed in commit 96be2f072768 ("mvebu: bubt: Drop dead code"). Reimplement
this functionality and bring it back again.
Fixes: 96be2f072768 ("mvebu: bubt: Drop dead code")
Signed-off-by: Pali Rohár <[email protected]>
|
|
Signed-off-by: Wolfgang Denk <[email protected]>
|
|
This commit removes text that is exact duplicated of the text above.
Cc: Konstantin Porotchkin <[email protected]>
Signed-off-by: Baruch Siach <[email protected]>
Reviewed-by: Stefan Roese <[email protected]>
|
|
Fix the MMU mapping for A8K device family:
- Separate A7K and A8K memory mappings
- Fix memory regions by including IO mapping for all
3 PCIe interfaces existing on each connected CP110 controller
Add A8K memory mapping documentation with all regions
configured by Marvell ATF.
Change-Id: I9c930569b1853900f5fba2d5db319b092cc7a2a6
Signed-off-by: Konstantin Porotchkin <[email protected]>
Signed-off-by: Stefan Roese <[email protected]>
Cc: Stefan Roese <[email protected]>
Cc: Nadav Haklai <[email protected]>
Cc: Neta Zur Hershkovits <[email protected]>
Cc: Omri Itach <[email protected]>
Cc: Igal Liberman <[email protected]>
Cc: Haim Boot <[email protected]>
Cc: Hanna Hawa <[email protected]>
|
|
Add support for mvebu bubt command for flash image
load, check and burn on boot device.
Signed-off-by: Konstantin Porotchkin <[email protected]>
Reviewed-by: Stefan Roese <[email protected]>
Cc: Stefan Roese <[email protected]>
Cc: Nadav Haklai <[email protected]>
Cc: Neta Zur Hershkovits <[email protected]>
Cc: Omri Itach <[email protected]>
Cc: Igal Liberman <[email protected]>
Cc: Haim Boot <[email protected]>
Cc: Hanna Hawa <[email protected]>
Signed-off-by: Stefan Roese <[email protected]>
|
