|
* [bsp][esp32-c6] add ESP32-C6-DevKitC-1 support
Add bsp/ESP/ESP32_C6. Default image is GPIO, UART0 and ADC. The C6 IDF sources are not in RT-Thread-packages/esp-idf yet.
* [bsp][esp32-c6] fix CI format, C6 package and CH32V203 D6 build
clang-format the files the format check rejected. Fetch the C6 scons
branch when the downloaded ESP-IDF package has no C6 target. Patch the
CH32V20x SDK under libraries so a D6 build no longer calls Exit().
* [bsp][esp32-c6] fetch mbedtls and stop pkgs from pulling the C6 branch
* [bsp][esp32-c6] rebuild CI against the package branch tip
* [bsp][esp32-c6] rebuild CI against the strict-mode package tip
* [bsp][esp32-c6] fix the reviewed ADC, math and package pin bugs
Keep the IDF tree on the reviewed commit, and stop the ADC and critical-section paths from reporting success when they did not.
* [bsp][esp32-c6] reserve stuck interrupt lines and lock ADC
CPU lines 3 and 4 never latch an enable, so copying the handler left the non-IRAM mask on the old line. Reserve those lines and let the allocator write the mask and the route together. The C6 oneshot registers are shared, so one mutex covers enable and convert.
* [bsp][esp32-c6] list the peripherals this board actually runs
GPIO, UART0 and ADC1 have been read on the DevKitC-1. Radios and the untested buses stay marked unsupported.
* [bsp][esp32-c6] keep SPI unsupported after the loopback mismatch
GPIO7 shorted to GPIO2 returned 0xA5000000 for a sent 0xA5, so the table does not mark SPI supported.
---------
Co-authored-by: seteiro <[email protected]>
|
|
- libraries/N32_Drivers: add ADC/DAC/I2C/SPI config headers for the
h47x_48x, h49x and h7xx series, and extend the shared drivers
(adc, dac, eth, gpio, hard_i2c, nand, qspi, sdram, spi, usart, wdt).
- n32h487zgl7-evb / n32h497zgl7-evb: add board ports (femc_timing,
phy_reset, usb_config) and update Kconfig, SConscript, rtconfig and
the IAR/Keil project files.
- n32h760zil7-stb: update Kconfig and rtconfig.
- CI: register the three n32hxxx boards.
|
