summaryrefslogtreecommitdiff
path: root/drivers/misc/nvmem.c
AgeCommit message (Collapse)Author
2026-01-13misc: Add fixed-layout supportMarek Vasut
The "fixed-layout" nvmem controller subnode used to be optional wrapper around nvmem controller cells subnodes. The "fixed-layout" node is now mandatory in most cases, but in order to support both recent and legacy DTs, both variants have to be supported. Implement support for the "fixed-layout" node in the most trivial manner, check whether the nvmem cell supernode is compatible with "fixed-layout" and if it is, proceed one level above it to find the nvmem controller. Signed-off-by: Marek Vasut <[email protected]>
2024-05-20Restore patch series "arm: dts: am62-beagleplay: Fix Beagleplay Ethernet"Tom Rini
As part of bringing the master branch back in to next, we need to allow for all of these changes to exist here. Reported-by: Jonas Karlman <[email protected]> Signed-off-by: Tom Rini <[email protected]>
2024-05-19Revert "Merge patch series "arm: dts: am62-beagleplay: Fix Beagleplay Ethernet""Tom Rini
When bringing in the series 'arm: dts: am62-beagleplay: Fix Beagleplay Ethernet"' I failed to notice that b4 noticed it was based on next and so took that as the base commit and merged that part of next to master. This reverts commit c8ffd1356d42223cbb8c86280a083cc3c93e6426, reversing changes made to 2ee6f3a5f7550de3599faef9704e166e5dcace35. Reported-by: Jonas Karlman <[email protected]> Signed-off-by: Tom Rini <[email protected]>
2024-05-07misc: Remove <common.h> and add needed includesTom Rini
Remove <common.h> from this driver directory and when needed add missing include files directly. Signed-off-by: Tom Rini <[email protected]>
2022-06-08misc: Add support for nvmem cellsSean Anderson
This adds support for "nvmem cells" as seen in Linux. The nvmem device class in Linux is used for various assorted ROMs and EEPROMs. In this sense, it is similar to UCLASS_MISC, but also includes UCLASS_I2C_EEPROM, UCLASS_RTC, and UCLASS_MTD. New drivers corresponding to a Linux-style nvmem device should be implemented as one of the previously-mentioned uclasses. The nvmem API acts as a compatibility layer to adapt the (slightly different) APIs of these uclasses. It also handles the lookup of nvmem cells. While nvmem devices can be accessed directly, they are most often used by reading/writing contiguous values called "cells". Cells typically hold information like calibration, versions, or configuration (such as mac addresses). nvmem devices can specify "cells" in their device tree: qfprom: eeprom@700000 { #address-cells = <1>; #size-cells = <1>; reg = <0x00700000 0x100000>; /* ... */ tsens_calibration: calib@404 { reg = <0x404 0x10>; }; }; which can then be referenced like: tsens { /* ... */ nvmem-cells = <&tsens_calibration>; nvmem-cell-names = "calibration"; }; The tsens driver could then read the calibration value like: struct nvmem_cell cal_cell; u8 cal[16]; nvmem_cell_get_by_name(dev, "calibration", &cal_cell); nvmem_cell_read(&cal_cell, cal, sizeof(cal)); Because nvmem devices are not all of the same uclass, supported uclasses must register a nvmem_interface struct. This allows CONFIG_NVMEM to be enabled without depending on specific uclasses. At the moment, nvmem_interface is very bare-bones, and assumes that no initialization is necessary. However, this could be amended in the future. Although I2C_EEPROM and MISC are quite similar (and could likely be unified), they present different read/write function signatures. To abstract over this, NVMEM uses the same read/write signature as Linux. In particular, short read/writes are not allowed, which is allowed by MISC. The functionality implemented by nvmem cells is very similar to that provided by i2c_eeprom_partition. "fixed-partition"s for eeproms does not seem to have made its way into Linux or into any device tree other than sandbox. It is possible that with the introduction of this API it would be possible to remove it. Signed-off-by: Sean Anderson <[email protected]>